It is official we have purchased a 1979 Morgan 382 – SV Pilgrim.
After spending time aboard all three of our top choices –
Tartan 37, Bristol 35.5, & Morgan 382, we choose to purchase the
Morgan. Why the 382?
We were swayed by the recommendations we found by current
and past owners on line. Consistently
the design received praise as a sturdy, comfortable vessel capable of bluewater
sailing. Along with chronicles of full
time cruisers living aboard M382s, I found many accounts of Morgan 38’s
completing ocean transits and circumnavigations.
First hand observations…
On deck the M382’s 6” bulwarks and cabin top mainsheet set
her apart from the Tartan 37s or the Bristol 35.5.
Her cockpit is spacious and appears comfortable. We will need to get used to wheel steering.
The interior layout is fairly standard.
One standout feature is a separated shower stall in the
head. We were wowed by the amazing
amount of storage below decks – dramatically more than other vessels we
viewed. System’s wise the 382 has more fresh water and
fuel tankage than either the Tartan or the Bristol.
There are some down sides to the M382…
·
With a fin keel & skeg hung rudder She draws
5 feet - a foot more than either the Tartan or the Bristol centerboard designs.
·
Due to fine entry lines her vee berth is on the
narrow side – smaller even than the vee berth in C’est la Vie, a Morgan 34.
·
She is powered with 30HP Yanmar. By modern standards 30HP is not much for a
vessel displacing 18,000 pounds. C’est
la Vie, our M34, displaces 12,500 and has a 34HP engine.
A bit of timing and chance also fit into the purchase. For the price we were unable to find a Tartan
or a Bristol that matched the condition and systems present on SV Pilgrim.
We have very little information on her history.
We believe she is hull #115. In the 90’s she was named Pupa
and based in the Miami, FL area. Circa
1998 she was purchased by the most recent owners and moved to Lake Erie. They did a wonderful job maintaining
her. Both inside and out her paint and
brighwork are in good condition. They replaced
the rig and ran all the control lines aft in 2002. The engine was rebuilt in 2010. Recently they have replaced all the ports
with new stainless steel NFM ports. The
dodger appears to be brand new.
There is work to be done…
1.
Replace main sail
2.
Replace all Running Rigging
3.
Update Electrical System – control panel,
lighting, battery bank, etc. – much of this will be pulled from C’est la Vie
4.
Install PV System & Solar Panels – pulled from
C’est la Vie
5.
Install Wind Generator – pulled from C’est la
Vie
6.
Update instruments – VHF, wind, depth, plotter,
etc. – much of this will be pulled from
C’est la Vie
7.
Replace current LP stove with stove from C’est
la Vie
8.
Improve storage & handling on foredeck. – add a second anchor roller, and the windlass from C’est la Vie
9.
New antifouling paint.
I’m certain the list will evolve and
grow once we spend some time aboard. But
first we need to get her down to Beaufort, NC.
We have contracted a trucking company to haul her south. They promise to have her in Beaufort by
December 15.
We have started a new website devoted to SV-Pilgrim - M382Pilgrim@blogspot.com We hope you all will continue to follow our adventures as we continue towards the horizon.
